Firmware 1.0.3.4

1. Get a clean USB flash drive that is 32 GB or smaller and make sure it is FAT formatted.
2. Download MWTV2 1.0.3.4 firmware file and extract it to a local drive on your PC.
3. Copy the file aeimwtv2.bin to the main "root" directory of the USB flash drive.

1. Power off the MWTV2 Tx device by unplugging the power cable.
2. Plug the USB flash drive into the MWTV2 Tx device USB port.
3. Plug the power into the MWTV2 Tx device.
4. The upgrade will auto start and will take about 3 minutes to complete.
5. Power cycle the device once the picture returns to the screen.

1. Power off the MWTV2 Rx device by unplugging the power cable.
2. Plug the USB flash drive into the MWTV2 Rx device USB port.
3. Plug the power to the MWTV2 Rx device.

4. The upgrade will auto start and will take about 3 minutes to complete.

5. Power cycle the device once the picture returns to the screen.

Note: The upgrade status can be seen on the TV connected to the Rx device.  

1. Push the "Menu" button on the receiver. 
2. The firmware version is located in the bottom left-hand corner of the screen below the model number. 
3. It should now say "Rx [1.0.3.4] Tx [1.0.3.4]" if the upgrade was successful.